Adding and Editing Tag-Based VLANs

To add or edit a tag-based VLAN

1. Click Network in the main menu, and click the My Network tab.

   The My Network page appears.

2. Do one of the following:
   • To add a VLAN, click Add Network.
   • To edit a VLAN, click Edit in the desired VLAN’s row.

   The Edit Network Settings page for VLAN networks appears.

3. In the Network Name field, type a name for the VLAN.
4. In the Type drop-down list, select Tag Based VLAN.

   The VLAN Tag field appears.

5. In the VLAN Tag field, type a tag for the VLAN.

   This must be an integer between 1 and 4095.

6. In the Mode drop-down list, select Enabled.

   The fields are enabled.

7. In the IP Address field, type the IP address of the VLAN network's default gateway.

1. In the Subnet Mask field, type the VLAN's internal network range.
2. If desired, enable or disable Hide NAT.

   See Enabling/Disabling Hide NAT.

3. If desired, configure a DHCP server.

   See Configuring a DHCP Server.

4. Click Apply.

   A warning message appears.

5. Click OK.

   A success message appears.

6. Click Network in the main menu, and click the Ports tab.

   The Ports page appears.

7. In the DMZ/WAN2 drop-down list, select VLAN Trunk.
8. Click Apply.

   The DMZ/WAN2 port now operates as a VLAN Trunk port. In this mode, it will not accept untagged packets.

9. Configure a VLAN trunk (802.1Q) port on the VLAN-aware switch, according to the vendor instructions. Define the same VLAN IDs on the switch.
10. Connect the UTM-1 appliance's DMZ/WAN2 port to the VLAN-aware switch's VLAN trunk port.