Configuring the Terminal Server

To configure the terminal server

Click Network in the main menu, and click the Ports tab.
The Ports page appears.
Next to the Serial port, click Edit.
The Port Setup page appears.
In the Assign to drop-down list, select Terminal Server.
Additional fields appear.
Complete the fields using the information in the following table.
Click Apply.
For information on locating the appliance's Serial port, see The UTM-1 Edge N Series and UTM-1 Edge NW Series.

Terminal Server Fields

In this field…	Do this…
Port Speed	Select the Serial port's speed (in bits per second). The Serial port's speed must match that of the attached dialup modem. The default value is 57600.
Flow Control	Select the method of flow control supported by the attached device: RTS/CTS. Hardware-based flow control, using the Serial port's RTS/CTS signal lines. XON/XOFF. Software-based flow control, using XON/XOFF characters.
TCP Port	Type the TCP port that the terminal server should use for incoming and outgoing connections between the Serial port and the Internet.
Operation Mode	Select the terminal server's operation mode. If Active is selected, the Primary Server and Secondary Server fields appear.
Primary Server	Type the IP address or DNS name of the primary Telnet server to which the terminal server should connect, or click This Computer to specify your computer.
Secondary Server	Type the IP address or DNS name of the secondary Telnet server to which the terminal server should connect when the primary server is not available, or click This Computer to specify your computer.